20 LNR6100 Series Hard Drive Installation
Your NVR comes with a pre-installed hard drive, which you can replace or upgrade with a larger hard drive. Review the technical
specifications section for the maximum hard drive size supported by your unit.
20.1 Installing a Hard Drive
|
CAUTION
|
Make sure that the system is OFF and the power cable is disconnected before removing/installing the hard drive.
|
To install the hard drive:
-
Insert hard drive screws (4×) into the hard drive and tighten them half way.
-
Power off the system, and unplug all cabling from the system.
-
Remove the side panel screws (2×).
-
Remove the rear panel screws (4×). Carefully remove the cover.
-
Place the hard drive over the screw slots on the bottom panel, then slide the hard drive into place.
-
Connect the power and data cables to the hard drive.
-
Turn the system over carefully. Tighten the hard drive screws (4×) to secure the hard drive.
|
CAUTION
|
Hold the hard drive in place when turning the system over to prevent damage to the system.
|
-
Replace the cover and cover screws (4×).
|
Note
|
After installation, you must format the hard drive in order to use it with the system. See
Formatting Hard Drives
.
|
20.2 Removing the Hard Drive
|
CAUTION
|
Make sure that the system is OFF and ALL power adapters have been disconnected before removing/installing the hard drive.
|
-
Power off the system, and unplug all cabling from the system.
-
Remove the side panel screws (2×).
-
Remove the rear panel screws (4×). Carefully remove the cover.
-
Turn the system over and loosen the hard drive screws (4x), but do not remove them.
-
Disconnect the power and data cables from the hard drive.
-
Carefully turn the system over. Slide the hard drive and then lift it out of the system.
-
Replace the cover, rear panel screws (4×), and side panel screws (2×) if you do not plan to install another hard drive immediately.