15.1 Optimizing Face Detection Accuracy
The following are important camera installation notes to ensure accurate Face Detection. For full camera mounting instructions,
see your camera’s documentation at
lorex.com
.
-
Install in a bright area and avoid facing direct sunlight with strong backlights and dark shadows.
-
Choose a location where objects of interest will be no further than 15ft (4.5m) from the camera.
-
Position the camera 10ft (3m) off the ground to detect the full proportion of a face.
-
Angle the camera around 15° down from the level position.
-
Point the camera directly where objects of interest will be facing.
High Accuracy Face Detection Vs. Low Accuracy Face Detection:
Accuracy will be influenced by lighting conditions and the distance/angle of a person’s face to the camera. To distinguish
facial features, the camera must be positioned head on with a clear view of a person’s face. Obscured and partially/fully
covered faces will not be accurately captured. To improve the range of face detection in low light conditions, color night
vision will switch to black & white. If you cannot meet these requirements for installation, it may be best to follow the
guidelines for person and vehicle detection instead.
|
Note
|
This system supports face detection on all 8 channels, however only 2 E892AB cameras can be enabled at one time for optimized
detection capability.
|