10 Recording
By default, the system is set to immediately record video from connected cameras continuously, 24 hours a day. You can customize
the recording settings according to your needs.
10.1 Video Recording Types
The system supports the following recording types.
-
Recording—Continuous: Normal, continuous recording. A
icon is shown when recording is in progress.
-
Recording—Motion: The system records when motion is detected by the camera. An
icon is shown when motion is detected.
10.2 Main Stream and Sub Stream
The system employs two video recording streams, a Main Stream and a Sub Stream. Both Main Stream and Sub Stream recording
are enabled by default.
The Main Stream records high quality video to your system’s hard drive.
The Sub Stream records lower resolution video for efficient streaming to devices over the Internet. Sub Stream recording must
be enabled to view video recordings on a computer or mobile device.
10.3 Setting up Scheduled or Manual Recording
You can set the system to record based on a schedule or you can manually turn recording on and off. By default, the system
is set to record on an always on recording schedule.
To select between scheduled and manual recording:
-
Right-click and then select Manual Control>Record.
-
Under Main Stream, select how the system will record the Main Stream for each channel.
-
Auto: Main Stream Recording will follow the recording schedule.
-
Manual: The system will record the Main Stream continuously as long as this option is checked.
-
Off: The system will not record the Main Stream for this channel. This option is not recommended.
-
Under Sub Stream, select how the system will record the Sub Stream for each channel.
-
Auto: Sub Stream Recording will follow the recording schedule.
-
Manual: The system will record the Sub Stream continuously as long as this option is checked.
-
Off: The system will not record the Sub Stream for this channel.
-
Under Snapshot, select Enable to enable snapshot recording on each channel. Or, select Disable to disable snapshot recording.
-
Click OK to save changes.
10.4 Configuring Hard Drive Overwrite
When the hard drive is full, the system will overwrite the oldest recordings by default. This is recommended, as it makes
sure that your system will continue to record without any input from you. You can also set the system to stop recording once
the hard drive is full.
To configure hard drive overwrite:
-
Right-click and select Main Menu. Click
> Setting>General>General.
-
Under HDD Full, select Overwrite for the system to overwrite the oldest recordings when the hard drive is full. Or, select Stop Record for the system to stop recording when the hard drive is full.
-
Click OK to save changes.