7.1 Setting the Remote Control Address
If you have more than one system, you can set up your remote control to pair with a specific system.
To set the remote control address:
-
Right-click and click Main Menu. Enter the system user name and password.
-
Click
and then click Setting>General>General.
-
Under Device No., enter the address number you would like to assign to the remote control.
-
Click OK.
-
Using the remote control, press Add. Then enter the address number and press Enter.
|
Note
|
When entering the address number using the remote, make sure that you press three digits. A single-digit number should be
preceded by two zeros. A two-digit number should be preceded by one zero. For example, if you entered 8 as the Device No., you have to press Add then 008 on the remote.
|